Home / Guides

Heat pump or gas furnace for a Charlotte-area home?

Charlotte has long hot summers and short, mild winters, which shapes this choice more than brand or efficiency rating. Here is what the climate record says, what each system involves in your house, and what to ask before you compare quotes. You choose which contractors get your phone number.

The short answer

Every Charlotte home needs cooling, so the real question is what provides the heat: the same outdoor unit running in reverse (a heat pump), a gas furnace, or both (dual fuel). Charlotte's normal January low is just under freezing and its normal January high is in the low 50s, and the U.S. Department of Energy says air-source heat pumps can be used in all climates. A gas furnace suits homes that already have gas and ducts sized for it. What you have now usually decides which is cheaper to install.

The three setups

Heat pumpAll electricOne outdoor unit heats and cools. An indoor air handler moves the air and holds electric backup heat strips.
Gas furnace with air conditionerGas and electricThe furnace heats. A separate outdoor unit cools, sharing the furnace's blower and ducts.
Dual fuelBothA heat pump does the cooling and most of the heating. A gas furnace takes over in colder weather.

What Charlotte's climate record says

The National Weather Service publishes 30-year normals for Charlotte, covering 1991 to 2020.

JanuaryNormal daily high 52.3 and low 31.8 degrees Fahrenheit. The coldest month.
JulyNormal daily high 90.3 and low 69.9 degrees Fahrenheit. The hottest month.

Two things follow. First, cooling is the bigger job here: summer is long and hot, and whatever you buy, its cooling side will run for more of the year than its heating side. Second, a normal winter night bottoms out around freezing and the days climb back into the 50s. Those are averages, and colder nights do occur, but this is not a climate where the heating system fights deep cold for months.

What the U.S. Department of Energy says about heat pumps

From the Department of Energy's Energy Saver Guide:

  • Heat pumps are the most efficient form of electric heating, providing up to three times more heat than the energy they use.
  • They can cut electricity use for heating by about half compared with electric furnaces or baseboard heaters.
  • Air-source heat pumps are the most common type and can be used in all climates.
  • If the thermostat is set back by hand in a way that brings on the backup electric-resistance heat, that heat is more expensive to run. Use a thermostat designed for a heat pump.

That guide compares heat pumps with electric resistance heat, not with gas. Whether a heat pump or a gas furnace costs less to run in your house depends on your electricity and gas rates and on how efficient each unit is. We have not found a sourced comparison for Charlotte rates, so we do not give one. Ask each contractor to show the arithmetic for your house, using the rates on your own bills.

What you have now decides most of the cost

You have a heat pump today

Replacing it with another heat pump reuses the wiring, the ducts and the refrigerant line route. Switching to gas means a gas service to the house if there is none, gas piping to the furnace, a flue, and a different indoor unit. That is a larger job with more trades.

You have a gas furnace and air conditioner today

You can replace like with like, or change the outdoor unit to a heat pump and keep a furnace as the backup, which is dual fuel. Going all-electric means removing the furnace and fitting an air handler with electric backup heat, which may need a larger electrical circuit. Ask whether your electrical panel can take it, and what it costs if not.

Your ducts

Ducts are sized for the system they were built with, and they are the part of the job most often left out of quotes. Ask each contractor whether they measured the duct system, whether it suits the equipment they are proposing, and what duct sealing or changes are included. The Department of Energy guide says a contractor should give you the calculations used to size the system. Ask to see them.

Rules that apply in Charlotte

  • Permit. Replacing a heating or air-conditioning system needs a permit in North Carolina at any price. Mecklenburg County requires separate permits for heating and air-conditioning, electrical and plumbing work, so a change of fuel can add permits. The office is Code Enforcement, 980-314-CODE (2633).
  • License. Heating and cooling work needs a state license with no dollar minimum, and so does electrical contracting. The county will not issue the permit to an unlicensed installer.
  • Where the outdoor unit can sit. Charlotte's zoning ordinance says ground-mounted or wall-mounted mechanical equipment for single-family homes may not be placed in the setback along a street frontage, and may extend into a required side or rear setback by no more than half that setback's width. If a new system means moving the outdoor unit, check the spot before the pad is poured. Towns outside the city have their own rules.

Our permit guide covers the permit rule in more detail.

How to choose

A heat pump tends to suit you if:

  • You have a heat pump now, or no gas service at the house
  • You want one fuel and one piece of outdoor equipment
  • You are replacing an electric furnace or baseboard heat, where the Department of Energy puts the saving at about half

A gas furnace with an air conditioner tends to suit you if:

  • You have gas service, a flue and ducts sized for a furnace already
  • You prefer the warmer air a furnace delivers at the register
  • A like-for-like swap keeps the job simple

Dual fuel tends to suit you if:

  • You have gas now and want the heat pump to carry the mild days, with the furnace for the coldest ones
  • You accept higher equipment cost and two systems to maintain

Whichever you lean toward, ask at least one contractor to price the alternative. The difference between two written quotes for your own house is worth more than any general rule.

Questions to put to every contractor

  1. Which setup are you quoting, and why that one for this house?
  2. What size is the equipment, and can I see the sizing calculation?
  3. What are the model numbers of the outdoor unit, the indoor unit and the thermostat?
  4. For a heat pump: how much backup heat is included, and at what outdoor temperature is it set to come on?
  5. For dual fuel: at what outdoor temperature does the system switch to gas, and who sets that?
  6. What work is included on the ducts?
  7. Which permits are you pulling, and is the fee in the price?
  8. Does my electrical panel or gas line need any change?

Our guide on why HVAC quotes differ explains how to compare the answers, and repair or replace covers whether you need a new system at all.

How QuoteFlash fits in

Tell our agent what system you have, what fuel, and that you are weighing the options. The agent works for you. It matches you with up to five local contractors who are insured, and licensed where the state requires it. Their written quotes arrive in one place, and the agent explains the differences in plain terms, including which setup each contractor proposed. You choose which contractors get your phone number. Free for homeowners; contractors pay when matched. See heating and cooling quotes in the Charlotte area.

Heat pump and furnace questions

Is a heat pump enough for a Charlotte winter?

Charlotte's normal January low is 31.8 degrees and the normal high 52.3, according to the National Weather Service. The Department of Energy says air-source heat pumps can be used in all climates. Heat pump systems normally include backup heat for colder nights; ask how much and when it comes on.

Is a heat pump cheaper to run than a gas furnace?

It depends on your electricity and gas rates and the efficiency of each unit. Ask each contractor to work it out from your own bills. We have not found a sourced comparison for Charlotte.

Do I need a permit to switch from gas to a heat pump?

Yes. Replacing a heating or air-conditioning system needs a permit in North Carolina at any price, and a change of fuel can add electrical or plumbing permits.

Can I keep my existing ducts?

Often, but they should be checked against the new equipment. Ask each contractor what they measured and what duct work is in the price.

When do contractors get my phone number?

When you choose to share it with a particular contractor, after you have compared written quotes.

One minute now. Up to five quotes to compare.

Get my quotesFree, no obligation, and you choose who gets your number
Contractor in the Charlotte area?Get matched with verified homeowners who are ready for quotes.
Apply for your area