A tankless heater saves the most energy in homes that use little hot water, lasts longer, and never runs out, but it can struggle when several taps run at once and it changes the gas, venting or electrical work around it. Replacing a tank with the same kind of tank is the simplest job and usually needs no permit in North Carolina. Converting to tankless always needs one.
What each type does
A storage tank heats a fixed volume of water and keeps it hot until you use it. When the tank is empty you wait for it to recover. A tankless, or on-demand, heater has no tank. It heats water as it flows through, so it does not run out, but it can only heat so much water per minute.
What the U.S. Department of Energy says
These figures are from the Department of Energy's Energy Saver Guide. They are national, not specific to Charlotte.
- Energy use. In homes that use 41 gallons of hot water a day or less, on-demand heaters can be 24 to 34 percent more energy efficient than storage tank heaters. In homes that use a lot, around 86 gallons a day, the advantage falls to 8 to 14 percent.
- Demand at the same time. If you use hot water in several places at once, you may need two or more tankless heaters to keep up.
- Life. Most storage water heaters last 10 to 15 years. Tankless heaters can last more than 20.
- Installation. The guide notes that tankless systems have their own installation requirements and says to consult a certified technician before buying.
The pattern in those numbers matters more than any single one. The less hot water a household uses, the bigger the tankless saving in percentage terms, and the smaller the bill it is a percentage of. A large family gets the smallest efficiency gain and is the most likely to need a second unit.
A third option: heat pump water heaters
If your current heater is electric, the same guide says heat pump water heaters can be two to three times more energy efficient than conventional electric water heaters. They are tanks, so they behave like the heater you have, but the guide warns that the technology can pose installation challenges and that you should talk to an installer first. Ask about the space and air the unit needs and where its condensate will drain. Also ask whether the swap would still count as a like-for-like replacement for permit purposes, since the electrical rating changes.
What changes in your house with a conversion
A tank-for-tank swap reuses what is already there. A conversion to tankless usually does not. Ask each contractor to answer these in writing, because this is where conversion quotes differ:
- Gas supply. Will the existing gas line serve the new heater, or does it need to be upsized or rerun? Who does that work, and is it in the price?
- Venting. Can any of the old vent be reused? Where will the new vent leave the house?
- Electrical. Does the new unit need an outlet or a new circuit? An electric tankless heater is a different question from a gas one: ask whether your electrical service can carry it.
- Location. Is the heater staying where the tank was, or moving to an outside wall?
- Water connections and valves. Are service valves for flushing the unit included?
- Maintenance. What upkeep does the manufacturer require to keep the warranty valid, how often, and what does the contractor charge for it?
- Sizing. How did you choose this model for the number of bathrooms and people in the house, and what happens if two showers and the dishwasher run together?
A quote that answers all seven can be compared with another. A quote that says only "tankless installed" cannot.
The permit difference in North Carolina
This is the part national comparisons leave out. State law exempts a replacement water heater in a one- or two-family home from a permit only when a state-licensed contractor does the work and there is no change in fuel, energy source, location, capacity, or the routing and sizing of venting and piping.
So a conversion carries a permit, a fee and an inspection that a simple swap does not. That is not a reason to avoid converting. It is a reason to check that every conversion quote includes the permit and names who applies for it. In Charlotte the permit comes from Mecklenburg County Code Enforcement, 980-314-CODE (2633). A conversion quote with no permit line is either incomplete or assumes work will be done without one.
Plumbing and heating work needs a North Carolina state license at any price, and so does electrical contracting. Where licensed work is required, the county will not issue the permit to an unlicensed installer. More in our permit guide for Charlotte.
How to decide
Tankless tends to suit you if:
- Your household is small or uses hot water lightly
- You plan to stay in the home long enough to benefit from the longer life
- You want the floor space back, or you run out of hot water with a tank now
- The gas, venting and electrical changes are modest in your house
A tank tends to suit you if:
- Several people shower while appliances run
- The conversion would need long new gas or vent runs
- Your current heater has failed and you need hot water back quickly
- You would rather avoid a permit and inspection for a straightforward replacement
If you are unsure, ask for both: one quote for a like-for-like tank and one for a conversion, from the same contractor. The difference between the two is the real cost of converting in your house, which no national average can tell you. Our water heater cost guide explains how each quote is built.
How QuoteFlash fits in
Tell our agent what you have now and that you are weighing tank against tankless. It works for you and matches you with up to five local contractors who are insured, and licensed where the state requires it. Written quotes arrive in one place, and the agent explains where they differ, including which ones priced the permit and the gas or vent work. You decide which contractors get your phone number. Free for homeowners; contractors pay when matched. Start at water heater quotes in the Charlotte area.