Home / Areas / Matthews

Heating and cooling replacement quotes in Matthews

Matthews is older than most Charlotte suburbs and its homes are split between gas heat and heat pumps, so your neighbor's quote may not be for the job you need. Compare up to five written quotes, and you choose which contractors get your phone number.

1990median year built for single-family homes inside Matthews town limits
2,284 sq ftmedian heated area
Over 1 in 4homes recorded with electric heat
6 in 10homes with two full stories or more

Matthews has two kinds of system, so start by naming yours

In Huntersville or Ballantyne almost every home is recorded with gas heat. Matthews is different. Of about 8,400 single-family homes inside town limits, roughly seven in ten are recorded with gas heat and more than a quarter with electric heat. Most of the electric homes, about a fifth of the town, are recorded with a heat pump.

So the first line of any Matthews quote is the system type. A gas home is replacing an air conditioner, a coil and usually a furnace. A heat pump home is replacing one outdoor unit that heats and cools, plus an indoor air handler. If you are not sure which you have, watch the outdoor unit on a cold morning: if it runs while the heat is on, it is a heat pump.

Moving from one type to the other is possible, and it is a change of system type, not a like-for-like replacement. If one contractor suggests it, have the others price the same change.

Age: three in four homes were built before 2000

Nearly half of Matthews homes were built before 1990 and more than a quarter in the 1990s. Fewer than one in ten has been built since 2010. A home built before 2000 is at least 27 years old.

In a house that old, the system being replaced is often not the original, and the ductwork may be older than the equipment attached to it. That makes ductwork the line to press on in Matthews. Ask each contractor whether they looked at the ducts in the attic or crawl space, what they found, and what the quote does about it. If your equipment dates from before 2010, it may run on R-22, a refrigerant that has not been made or imported in the United States since January 1, 2020. Existing R-22 systems can still be serviced.

Size and layout

The median heated area is 2,284 square feet. About six in ten homes have two full stories or more, and a small share, about one in fifty, are split-level or bi-level. Some two-story homes of this size have two systems and some have one serving both floors, so count your outdoor units. In a split-level, ask how each level is supplied and whether the contractor checked it.

What to check on a Matthews quote

  • System type stated plainly, and the same type on every quote.
  • For a heat pump: the backup heat strips and their size. For gas: whether the furnace is included.
  • What was found in the ductwork and what will be sealed, repaired or replaced.
  • How the size was worked out. A home that has gained insulation or windows since it was built may not need the size it has now.
  • The permit and the contractor's license number.

The complete checklist is on our heating and cooling page. For help lining quotes up, read why HVAC quotes differ and how to read a contractor quote.

Permits and licensing in Matthews

Mecklenburg County Code Enforcement (980-314-CODE) issues building and trade permits for Matthews addresses in Mecklenburg County. North Carolina requires a permit to replace a heating or air conditioning system whatever the job costs, and the installer must hold a state heating and cooling license at any price. The permit cannot be issued unless a licensed contractor is doing the work, so the contractor applies for it, not you. A change of fuel or system type does not remove the need for a permit. Our permit guide for Charlotte and nearby towns covers other projects.

How QuoteFlash fits in

QuoteFlash is free for homeowners. You describe the house and the system to our agent, which works for you, and verify your phone by text code. You are matched with up to five local heating and cooling contractors who are insured, and licensed where the state requires it. Their written quotes arrive in one place and the agent explains the differences. Contractors pay when they are matched.

Matthews heating and cooling questions

Are heat pumps common in Matthews?

More common than in most nearby areas. About a fifth of single-family homes inside town limits are recorded with a heat pump, and roughly seven in ten with gas heat.

Should I switch my Matthews home from a heat pump to gas, or the other way?

Either can be quoted, but it changes the job: different equipment, and possibly gas piping, venting or electrical work. Ask every contractor to price the same option so the totals can be compared.

Can the old ductwork in a 1980s Matthews house be reused?

Sometimes. It depends on its condition, and only someone who has looked can say. The quote should state what was inspected and what will be sealed, repaired or replaced.

Who issues the HVAC permit in Matthews?

Mecklenburg County Code Enforcement. The contractor applies for it, and a permit is required for a replacement at any price.

One minute now. Up to five quotes to compare.

Get my quotesFree, no obligation, and you choose who gets your number
Contractor in the Charlotte area?Get matched with verified homeowners who are ready for quotes.
Apply for your area