Ballantyne is part of Charlotte and has no boundary of its own, so the figures on this page cover the 28277 ZIP code: about 16,400 single-family homes in Ballantyne and the neighboring parts of south Charlotte.
Two systems is the starting assumption here
The median heated area is 2,859 square feet, the largest of the Mecklenburg County areas we have figures for, and about eight in ten homes have two full stories or more. A home like that often has two separate systems, one per floor, and each is its own replacement job with its own outdoor unit, indoor unit and ductwork. Count the outdoor units before you ask for quotes.
Then ask where each indoor unit sits. Equipment in an attic or crawl space takes more labor to replace than equipment in a closet or garage, so the upstairs and downstairs systems in one house can be priced differently. A quote for "the system" in a two-system house is not finished until it says which one.
Nearly every home is an air conditioner plus a gas furnace
About nineteen in twenty homes in 28277 are recorded with gas heat and ducted forced air. Heat pumps are roughly one home in twenty. That makes the common Ballantyne job a matched air conditioner, coil and gas furnace. If a contractor proposes a heat pump or dual fuel, that is a change of system type, and the other contractors should be asked to price the same change before you compare totals.
Age: nine in ten homes were built before 2010
More than seven in ten homes here were built in just two decades, the 1990s and the 2000s. Only about one in ten has been built since 2010. The median home dates from 1998, which makes it 28 years old.
In a house that age, the system you are looking at may already be a replacement. If so, the earlier installer's choices about size, ducts and refrigerant lines are what the next one inherits, and it is worth asking each contractor whether they agree with them. If the equipment is original and dates from before 2010, it may run on R-22, a refrigerant that has not been made or imported in the United States since January 1, 2020. Existing R-22 systems can still be serviced. In a two-system house one system has often been replaced and the other has not, so check the label on each outdoor unit.
What to check on a Ballantyne quote
- Which system the quote covers, and a separate price for each if you asked about both.
- Model numbers for the outdoor unit, coil and furnace of each system.
- A size worked out for each floor on its own, not copied from the old units.
- Where the indoor unit is, and what attic or crawl space work is included.
- The permit, the license number and both warranties in writing.
We keep the full quote checklist on our heating and cooling page, and the general method in how to read a contractor quote.
Permits and licensing in Ballantyne
Ballantyne addresses are in the City of Charlotte, and Mecklenburg County Code Enforcement (980-314-CODE) issues the permit. North Carolina requires a permit to replace a heating or air conditioning system whatever the job costs, and the installer must hold a state heating and cooling license at any price. The permit cannot be issued unless a licensed contractor is doing the work, so the contractor applies for it, not you. Replacing two systems means the permit should cover both. See our permit guide for Charlotte and nearby towns for other projects.
How QuoteFlash fits in
QuoteFlash is free for homeowners. You describe the house and the system to our agent, which works for you, and verify your phone by text code. You are matched with up to five local heating and cooling contractors who are insured, and licensed where the state requires it. Their written quotes arrive in one place and the agent explains the differences. Contractors pay when they are matched.