These figures cover about 15,400 single-family homes inside Mooresville town limits. Many homes with a Mooresville mailing address are outside the limits and are not counted.
Permits first, because this changed in 2023
The Town of Mooresville has its own Building Permitting & Inspections Department, created in 2023, at 750 W. Iredell Avenue in One Mooresville Center (704-799-4268). Before that, town residents got permits from the Iredell County Building Standards Division in Statesville, so older advice may still point there. If your home is outside the town's jurisdiction, check which office covers your address before work starts.
The state rules are the same either way. North Carolina requires a permit to replace a heating or air conditioning system whatever the job costs, and the installer must hold a state heating and cooling license at any price. The permit cannot be issued unless a licensed contractor is doing the work, so the contractor applies for it, not you. Ask for the permit number once it is issued. Our permit guide for Charlotte and nearby towns explains the state rules for other projects.
Gas in most homes, heat pumps in about one in six
About eight in ten homes inside town limits are recorded with gas heat and about one in six with electric heat, nearly all of those with a heat pump. A small number, about two in a hundred, are recorded with oil, wood or coal as the heating fuel.
That is a higher heat pump share than in Huntersville or Cornelius just to the south, so do not assume. A gas home is replacing an air conditioner, a coil and usually a furnace. A heat pump home is replacing an outdoor unit and an air handler, and the quote should list the backup heat strips. If the outdoor unit runs while the heat is on, you have a heat pump.
About 3 homes in 100 have no central air
Mooresville is the one town near Charlotte where we have a figure for central air: 97% of homes are recorded with it. The remaining 3% is roughly 400 homes. If yours is one of them, what you need is not a replacement. It is a first central or ductless system, which can mean new ductwork and new electrical work, and contractors will propose different designs. Say so at the start so every quote is for the same thing.
Age and size
Four in ten homes have been built since 2010 and about a quarter in the 2000s. About one in three is older than that, split almost evenly between the 1990s and earlier. The median home dates from 2005.
In the newest group the system is probably original and under 17 years old, so ask for the repair price alongside any replacement quote. In homes from before 2010 with original equipment, the system may run on R-22, a refrigerant that has not been made or imported in the United States since January 1, 2020. Existing R-22 systems can still be serviced. The median heated area is 2,341 square feet, and a little under six in ten homes have two full stories or more. Count your outdoor units: at that size some two-story homes have two systems and some have one.
What to check on a Mooresville quote
- System type, the same on every quote.
- Which permit office the contractor will apply to, and the permit number.
- For a home without central air, the full design: ducts, electrical work and where equipment goes.
- How the size was worked out.
- The contractor's state license number.
The full checklist is on our heating and cooling page, and the general method is in how to read a contractor quote.
How QuoteFlash fits in
QuoteFlash is free for homeowners. You describe the house and the system to our agent, which works for you, and verify your phone by text code. You are matched with up to five local heating and cooling contractors who are insured, and licensed where the state requires it. Their written quotes arrive in one place and the agent explains the differences. Contractors pay when they are matched.