A 1,540 square foot house leaves little room for a sizing mistake
There are about 19,500 single-family homes inside Rock Hill city limits, and their median size is 1,540 square feet. That is the smallest of any town around Charlotte that we have figures for, and more than 1,000 square feet under Fort Mill and Tega Cay to the north.
Heating and cooling equipment comes in fixed steps of capacity. On a large house, one step up or down is a small change. On a 1,540 square foot house it is a large one. Bigger is not better: an oversized system reaches the set temperature quickly, switches off, and takes less moisture out of the air, which is what you notice in a Carolina summer. So if two Rock Hill quotes propose different sizes, do not split the difference and do not default to the larger. Ask each contractor how they arrived at the number. The one to trust is the one who measured the house and did a load calculation.
A home this size is usually served by one system, but count the outdoor units to be sure.
Age: two groups of homes
Nearly half of Rock Hill homes were built before 1990. About one in four was built between 2000 and 2009, roughly one in eight in the 1990s, and about one in seven since 2010.
In a home from before 1990, the equipment has usually been replaced before and the house may have changed since the ducts went in. New windows or added insulation lower the load, which is another reason not to copy the size of the old unit. Ask what the contractor found in the ductwork.
In a home from the 2000s, now 17 to 26 years old, the system may still be the builder's original. Check the label on the outdoor unit. Equipment made before 2010 may run on R-22, a refrigerant that has not been made or imported in the United States since January 1, 2020. Existing R-22 systems can still be serviced. And a new system will use a different refrigerant from any system installed before 2025, because federal rules changed which refrigerants can go into newly installed systems from January 1, 2025.
First, work out what you have
We have no figures on how Rock Hill homes are heated. If the outdoor unit runs while the heat is on, it is a heat pump. If you have a furnace with a flue and a gas line, you have gas heat and a separate air conditioner. Tell the agent which, so that every quote is for the same type.
What to check on a Rock Hill quote
- The size in tons, and whether it came from a load calculation.
- Any difference in size between quotes, with each contractor's reason.
- What was inspected in the ductwork, in an older home.
- Model numbers for the outdoor and indoor units.
- The permit and the contractor's South Carolina license number.
Sizing is one of nine lines covered in why HVAC quotes differ. The complete checklist is on our heating and cooling page, and the general method is in how to read a contractor quote.
Permits and licensing in Rock Hill
South Carolina law treats heating and air conditioning installers as residential specialty contractors on jobs over $500 and requires them to hold a state license issued after an examination. The office that issues permits must refuse one unless the applicant shows that license. Ask for the license number and check it with the state before you sign.
We could not read the City of Rock Hill's own permit pages when preparing this page, so we do not state the City's rules for a replacement. Ask the City's building department whether your job needs a permit, ask your contractor who will obtain it, and ask for the permit number.
How QuoteFlash fits in
QuoteFlash is free for homeowners. You describe the house and the system to our agent, which works for you, and verify your phone by text code. You are matched with up to five local heating and cooling contractors who are insured, and licensed where the state requires it. Their written quotes arrive in one place and the agent explains the differences. Contractors pay when they are matched.