Six things set the price of a siding job: the wall area, the material, whether the old siding is removed, what is found and fixed behind it, how much trim is replaced, and paint. In North Carolina, replacing siding on a single-family home needs no building permit when the job costs $40,000 or less, unless load-bearing framing has to be repaired. We do not print a Charlotte price range because we have not found one backed by a method.
How a siding quote is built
Siding contractors measure the outside walls and price by the "square," which is 100 square feet of wall. From there a complete quote adds, line by line:
- Tear-off and disposal of the old siding
- The weather barrier behind the siding: house wrap and the flashing around windows, doors and penetrations
- Siding material, with an allowance for waste and cuts
- Trim: corner boards, window and door surrounds, and often soffit and fascia
- Repairs to sheathing or framing found behind the old siding
- Paint or finish, if the product is not pre-finished
- Permit, if the job needs one
A quote that shows only a total has all seven inside it, or is missing some. You cannot tell which until you ask.
The six drivers
1. Wall area and shape
Wall area is not the same as the floor area of the house. A two-story home has roughly twice the wall of a single-story home with the same footprint, and gables add more. Windows and doors reduce the siding but add cutting and trim. Height adds labor too: upper stories need scaffolding or lifts. If two contractors report different numbers of squares for your house, ask both how they measured and whether openings were deducted.
2. Material
Vinyl, fiber cement, engineered wood, natural wood and brick or stone veneer sit at very different price levels, for the material and for the labor to hang it. Heavier products take more crew time. Within each material there are grades: thickness, profile, and factory-finished or primed for painting. A quote should give the manufacturer, product line, profile, exposure and color, not just "fiber cement."
3. Tear-off or cover-over
Some quotes price new siding over the old. That saves the tear-off but hides whatever is behind the wall and can leave windows sitting deeper than the new surface. Others remove everything down to the sheathing. Make sure all of your quotes assume the same thing.
4. What is behind the old siding
This is the largest unknown. Water that got past failed siding or bad flashing may have rotted the sheathing or the framing, and nobody can see it until the wall is open. A careful quote gives a price per sheet of sheathing replaced and an hourly or unit price for framing repair. Without those, the price of the surprise is set after your wall is already open.
5. Trim, soffit and fascia
Replacing trim, soffit and fascia can add a large share to the job, and quotes differ on whether it is included, wrapped in metal, painted, or left alone. Ask for trim as its own line, with the material named.
6. Paint and finish
Factory-finished products arrive in color. Primed products need painting after installation, which is sometimes a separate contractor and a separate price. Check that caulking and touch-up are included.
Windows, gutters and other work that touches siding
If you plan to replace windows within a few years, ask about doing it with the siding. The flashing around a window is easiest to get right when the wall is open, and it avoids cutting into new siding later. Gutters and downspouts normally come off for a siding job. The quote should say whether they are put back or replaced. See window replacement cost drivers.
The permit rule in North Carolina
State law names exterior siding replacement as work that needs no building permit in a single-family home when the job costs $40,000 or less.
The third row matters. A siding job that starts without a permit can come to need one if the crew opens the wall and finds rotted studs or other structural damage. Ask each contractor what they will do in that case and who applies. For Charlotte addresses, permits come from Mecklenburg County Code Enforcement, 980-314-CODE (2633). Our permit guide has the full list by project.
The license rule
North Carolina requires a general contractor license when a job costs $40,000 or more. Whole-house siding in a premium material, with trim and paint, can reach that figure. If your quotes are near it, ask each contractor which license they hold, and look the number up with the state board. Below $40,000 that license is not required, so written proof of insurance, a written workmanship warranty and a detailed quote carry more weight.
Homes built before 1978
Federal rules apply when paid work disturbs painted surfaces in homes built before 1978, because paint of that age may contain lead. The U.S. Environmental Protection Agency requires any firm paid to do that work to be certified, and its workers trained. Tearing painted siding and trim off an older home disturbs paint. Ask for the firm's lead-safe certification, and check that containment and cleanup are in the price.
HOA approval
In many Charlotte-area communities, a change of siding material, profile or color needs approval from the HOA before work starts, even when no permit is required. Some communities limit which materials may be used at all. Read the rules before choosing a product, and ask the contractor for the product sheet and color sample your application needs. Our guide to HOA approval for exterior projects covers what to submit and when.
What a complete siding quote lists
- Number of squares, and how they were measured
- Tear-off or cover-over, and disposal
- House wrap and flashing: product and where it goes
- Siding manufacturer, product line, profile and color
- Trim, soffit and fascia: what is replaced, with what
- Unit prices for sheathing and framing repair
- Painting and caulking: included or not
- Gutters and downspouts: reinstalled or replaced
- Permit: whether one is needed, and who applies if structural damage is found
- Manufacturer and workmanship warranties, and who registers the manufacturer's
- Start date, duration and payment schedule
Our guide on how to compare contractor quotes explains how to line these up.
How QuoteFlash fits in
Describe your home and the siding you have to our agent, which works for you. It matches you with up to five local contractors who are insured, and licensed where the state requires it. Their written quotes arrive in one place and the agent explains the differences: tear-off or cover-over, what trim is included, and who priced repairs. You choose which contractors get your phone number. It is free for homeowners. Contractors pay when they are matched. Start with siding and gutter quotes in the Charlotte area.